Lengthening the Ultraviolet Tee (option 1)

If you’re not keen on the “slightly cropped” aspect of View A of the Ultraviolet Tee (or if you have a particularly long torso) but you want to keep the gentle curve on the front and back and the scoop on the side, this is how you go about lengthening your pattern pieces. This is also the same process for lengthening View B. Since the pattern pieces are essentially straight at the sides, it’s just about as easy as can be to make the pattern longer. 1 – Cut the pattern along the lengthen/shorten line on both the Front and Back. 2 – Separate the pattern pieces the amount you would like to lengthen the shirt. 2-3 inches will bring the shirt down to a non-cropped length (like the sample shirt pictured in this post). 3 – Connect the pattern pieces and fill in the gap.

How to Sew the Soft V Neck on the Laminaria Swimsuit

The soft V neck on the Laminaria Swimsuit is really easy to sew and gives you results that are almost as nice as the sharp V neck, so if you’re not looking to give yourself an extra challenge, this is the way to go. Cut your elastic to the length described in the instructions. Mark the center of the elastic with a pen. You can go ahead and write with a ball-point pen or permanent marker (instead of a wash-away marker) since it won’t be seen in the finished suit. Pin the elastic to the inside of the suit. I like to use pins horizontally so I can take them out as I sew. The elastic is the same length as the fabric here so no need to stretch or gather anything. Make sure that your center mark aligns with the center of the V. The exact position of the …

2

How to Sew the Laminaria Swimsuit with a Mesh Insert

When I was designing the Laminaria Swimsuit I intentionally placed the contrast insets such that they could be sewn in mesh without the swimsuit becoming scandalous. The easiest way to do so is to use mesh for the inserts in View A and use a mesh or skin color lining. However if you take the easy approach your seam allowances may be visible at the edges of your mesh. If you want to guarantee that the mesh looks as clean as possible there are a few changes that you need to make to cutting and construction. They’re not technically challenging but they do require understanding the suit construction so I’d strongly recommend sewing the suit with a standard inset following the normal directions once before attempting mesh. Start by cutting View A out of your fabric using mesh for the inserts. Instead of a full lining, you will cut the lining out of …