At this point in the Swimsuit Sewalong, I’ve sewn a lot of swimsuits. And I think I must say that this hack makes this bikini bottom my favorite. While it’s super easy to turn a basic bikini bottom into a high waist pattern, it turns out that it’s a pretty simple hack to turn the Nautilus Swimsuit View B (the one with the cool twists on the bottom) into a high waist and keep the twists! Yes! Before you do this hack, you probably want to read through the sewalong for View A (the one piece) as the join from top front to top bottom around the twist is very similar to the join for this hack.
The first decision you need to make is how much extra height you want to add to the pattern. As written, it’s low rise. I added 3″ to the finished suit to bring it up to a mid rise, a couple of inches below my navel. You can add less or more as you see fit.
Cut two strips of fabric and two strips of lining that are the height you want to add to your suit + 1/2″ (because there is a 1/4″ seam allowance on the top and bottom of the strip).
Sew the fabric right sides together and the lining right sides together so that the bottom of the strip is the width of the top of the nautilus bikini bottoms. The amount of taper you want from bottom to top of the strip depends on the shape of your body. My body tapers a lot toward my waist so I have a pretty strong taper. If yours doesn’t you can sew your strips with a more vertical side seam.
Sew the bottoms as directed in the instructions, leaving off any elastic along the top of the suit.
The elastic around your twist should stop right about at the seam between front lining and front facing (again, like sewing the top of View A). On the sides, you should stop the elastic at about the same distance around the curve as you do on the front (see the right side of the twist in this picture). Don’t continue the elastic all the way to the seam between side front and back as it is a longer distance than the distance to the facing on the front.
Sew the band to the bottoms in a sandwich of band fabric right side up, bottoms right side down, band lining right side down. When you reach the twists, allow them to pull up out of the seam (again, refer to the View A sewalong for a lot more details). Since you don’t have markings for where the twists should line up with the band (like you would when sewing the twists on View A), you can figure out where the twists should be in relation to the band by trying on the swimsuit and band and marking them on your body.
This is what the twist looks like tucking up into the top band.
Understitch across the gap to prevent your lining from being visible from the right side of your finished suit.
Sew elastic to the top of the suit, keeping tension on the elastic as you sew.
Fold the top to the inside and stitch it down.
Rock your new high waist suit – with twists!
*Thanks to Funkifabrics for providing the fabric for this tutorial*